Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.
Funeral and I noticed this back in 9.01. The patch I posted in there had the same behavior in 9.02. I tweaked some value same it went away, so I never reported it (beyond that post)
Im on 9.02 also. This behaviour occurs on my self made presets (1-56) in bank A which are the factory presets as a base but with lots of changes. When I change the Level parameter in adsr1 its defaulted at 0 ms, and when I turn the value wheel the slightest the parameter changes to % and the value starts at roughly 50%. I will investigate further tonight. Maybe the behaviour goes away if I make some changes and then store the changes. Will check.
Thanks for your help so far. Regards!
Funeral and I noticed this back in 9.01. The patch I posted in there had the same behavior in 9.02. I tweaked some value same it went away, so I never reported it (beyond that post)
I tweaked the adsr1 controller level parameter value and saved it but the issue didn't go away. It seems that the adsr1 controller level value don't get stored.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.