Poparad
Power User
Using the FX loop as a switchable on/off loop in the FM3 is a bit cumbersome currently. If you add Out2 and In2 blocks into your path, it'll work just fine as an always-on loop, but if you try and bypass the loop, your signal within the FM3 isn't bypassed through the blocks; it just stops dead in its tracks. It's possible to make a bypassable loop with additional blocks and parallel routing, but I feel that this is a pretty basic thing that should be possible with only the Out2 and In 2 blocks connected to each other (I acknowledge that you can place them non-sequentially in a patch where this wouldn't work, and this is a behavior that's really clever and useful and should remain unchanged!).
I don't have my FM3 with me at the moment, but if I recall, either the Out or In block doesn't have a thru bypass mode like every other block does. Maybe adding this as a feature to the block would be an easy fix?
I don't have my FM3 with me at the moment, but if I recall, either the Out or In block doesn't have a thru bypass mode like every other block does. Maybe adding this as a feature to the block would be an easy fix?