A Schecter Guitar Project

I went to install the Schecter Brimstone Pickup this morning but it wasn't quite working out so I ordered some pickup mounting foam w/springs from stewmac:

Waiting on parts & supplies sucks!

pickup-height-foam-with-internal-springs.jpg
 
Ordered a Bareknuckle/CTS 550K pot for the volume control. When it arrives I should have everything needed. I'll try my hand at soldering this guitar wiring. I ordered two pots in case I mess up. If I don't mess up, then I'll have the pot needed for the Red Schecter Guitar Project.
 
The picking ring mount was just not working out for me, so I installed this direct mount bar. I'll finish mounting the Schecter Brimstone Pickup to the bar when I can determine the string height - when the guitar starts to get new strings. Thanks for looking!

DSCF8514.JPGDSCF8516.JPG
 
Back
Top Bottom