Lkdog
Power User
I created and saved a simple 4CM preset in AX8 Edit:
Input>Comp>Wah>Drive>FX LOOP>Volume/Pan>Gate> Delay>Chorus>Reverb> Output
Works fine with my CA Triptik with some minor noise gate applied.
On the AX8 unit itself the blocks show up in the layout tab, but do not show up in the FS tab.
The 8 blocks are just blank.
I am new Ax8 and AXE 8 Edit user.
Longtime AXE FX II XL user.
Maybe I am doing something wrong here?
Input>Comp>Wah>Drive>FX LOOP>Volume/Pan>Gate> Delay>Chorus>Reverb> Output
Works fine with my CA Triptik with some minor noise gate applied.
On the AX8 unit itself the blocks show up in the layout tab, but do not show up in the FS tab.
The 8 blocks are just blank.
I am new Ax8 and AXE 8 Edit user.
Longtime AXE FX II XL user.
Maybe I am doing something wrong here?