Bug? 10 Tap Delay

simeon

Axe-Master
not sure if this is a bug with the axe II (ares 1.02) or with axe edit (v3.14.4)

if you try to move the delay time parameter in axe edit, it either snaps back to the 12o/c position, or always shows 1000ms. it's fine from the front panel.
 
not sure if this is a bug with the axe II (ares 1.02) or with axe edit (v3.14.4)

if you try to move the delay time parameter in axe edit, it either snaps back to the 12o/c position, or always shows 1000ms. it's fine from the front panel.

Sorry to ask you;
Are you using a XL/XL+ or a II?

I cannot find any 10-Tap-Delay on the AxeFx II MK II, ARES 1.02, AxeEdit 3.14.4.
There's a Multi-Tap.
But everything works fine.

Regards
Mike
 
it's one of the algos in the multidelay. axe fx II.

;-)
Exactly; my fault.
Must have been a problem with my eyes ...
Ignored the MultiDelay ...
Same problem here.
The digits (values) are staying still there in the edit-field, but the taper is going back to zero/left side.

Thanx
Mike
 
Back
Top Bottom