relay

  1. R

    EVH 5150 iii Midi Switching

    Hi All, I just picked up an EVH 5150 EL 34 50 watt amp and I’m interested in changing amp Channels via midi on my FX8 Mark 2. I saw a video on YouTube that showed it should work but I’m having trouble. According to the video, PC number 0 is green, one is blue, and 2 is red... but I’m...
  2. A

    Cable connection for AX8, Wireless, ISP and two expression pedals

    Hello, I need your help about the TS or TRS cables...I already know that expression pedals and the output of the AX8 require TRS, but I have some questions about that. I have 1 guitar, 1 Line 6 Wireless Relay, 1 ISP Power Stealth, 1 AX8 and 2 expression pedals (EV2 and Mission)....how would...
  3. R

    FX8 Relay Question

    Hi All, I recently picked up a FX8 Mark ii to run with with my Peavey JSX. I purchased a cable from Best-ronics which is a 7 pin din to 1/4" TRS specifically for Peavey JSX/XXX. For some reason i can not access the Red/Ultra channel on the amp. When i plug in the fx8, it switches to the...
  4. Keg8605

    FX8 Relay's

    Hi quick question - so the relay on the FX8 is trs. A lot of amps are TS. I'm looking to have a snake made for an FX8 or AX8 setup. Does this mean I could have a trs cable included and use the y splitter adapters as needed on either end depending on the setup?
  5. Z

    FX8 Relay Switching issue with Friedman

    I received my new fx8 a few weeks ago, its awesome with my Smallbox 50. Running it in 4cm. I've run into a weird snag switching between scenes. There's a delay switching between two scenes in my created preset. Scene 4 is set clean on the friedman, with comp, peq, drive and reverb on x...
  6. S

    Is there a way to change scenes on footswitches 1-4 and use 5-8 as stomp boxes?

    Hi all. I recently got my fx8 Mark II and I've been writing some patches and trying to figure out the best way to configure it for each of my gigs, and I'm having trouble getting it to do what I'd like. Any help is much appreciated. I'm using it with the three channel Mesa Boogie Mark V, and...
  7. MRH

    Relay state change lag time

    I have my FX8's two TRS relays controlling four amp functions (channel change, mid-boost, gain-boost, and drive-max). The two TRS relays are properly connected to my Fuchs ODS-II, all functions enable/disable as expected. I typically dedicate three foot-switches to scenes (S1, S2 and S3) and...
  8. alexwald

    How to use Relay1 and Relay2 in auto-trigger with 3 scenes?

    let me explain. I have 3 scenes with my EVH 5150 III: 1) rhythm channel 2) crunch channel 3) clean in the preset, I have both relay1 (controls RHY channel) and relay2 (tip=clean channel, ring=crunch) block set to auto-off, auto-trigger, this is required because of how EVH switches channels...
Back
Top Bottom