humbuster cable

  1. S

    Hum buster question

    I’m setting up a temple Audio board with a 2x mod interface going out the side. Can I wire a trs-trs cable from the humbuster out to the interface and then plug the the humbuster cable itself out from the side of the board when I need to use an amp?
  2. S

    AFIII Axe FX3 lot of noise and ground problem :( help!

    Hi! unfortunately i have pretty bad grounding at home. I have already bought furman, new instrument cables, etc. Do you think that putting humbuster cables between the fx3 and the interface would help my problem? or some other tip maybe? Thanks.
  3. Xenoprimate

    Does the Axe-Fx III come with a Humbuster cable?

    ...Or do I need to purchase one as well as the unit? Thanks!
  4. PaulZ

    Wiring stereo humbuster outs to single TRS stereo in on Gemini2

    Can anyone tell me the correct way to wire the cables of a stereo humbuster output on a Fractal unit to the single TRS stereo input of a Mission Gemini 2? Also, hypothetically, if I was going to use an FM3 (wishful thinking, I know) on my temple audio pedalboard, can I make the adaptation from...
  5. Prorenzo

    Use Humbuster cables as regular instrument cables?

    Hi all, I have recently sold my AX8 and wondering if I could use the my existing humbuster cables as a regular guitar cable without any side effects. I intend to have this plugged from my pedals to my amp or mixing board. I was told that the signal may be weakened due to the TRS jack on one...
  6. MRH

    "Tone suck" issue---diagnostic regimen suggestions?

    I have been a FX8 (original device, upgraded firmware) user since 2016. Using a 4-cable setup with my Fuchs ODS-II very successfully since then. (Using two Humbuster cables for send to amp in, and back to amp effects loop return.) In recent months (not sure exactly when the change occurred)...
  7. plyall

    Humbuster cable users...

    Folks - Bad news: they're letting me out of the studio! I am getting ready to start working with a local band, and I don't want to un-cable the rig in the studio, so... I am thinking about getting some Humbuster cables for running between my Axe-FX II and my two CLR (powered) cabs. I know that...
Back
Top Bottom