Search results for query: *

  • Users: Cbaf
  • Order by date
  1. C

    Mark V Tone Match

    Hey guys. I am doing some tone matches on my Mark V (Channel 3) Mark IV setting. Now my understanding is that we should get the amp to match as close as possible before capturing the match. I am using the USA Lead Brt+ and the results were incredible. The tone match curve was actually almost...
  2. C

    AxeFX and Elevenrack

    I own both the II and ER as well. I have tried a few different options, but the method that works best for me is putting the II in the effects loop of the ER(ER send ->II rear input 1, II output 1 -> ER return). I basically then keep the ER on one preset with the loop engaged using all amps...
  3. C

    When to sell MV

    Thanks again guys for the great feedback. @Scary - I agree totally on the EL34 comments. I always seem to go back and forth between the 6l6s and EL34s due to liking one better for cleans (6l6) and the other for crunch/high gain (EL34). Hopefully with the new TM enhancements, I can get that...
  4. C

    When to sell MV

    Thanks guys for the feedback. To clarify, my question was aimed at if I should wait and redo my tone matches. I have already made the decision to eventually sell the Mark. Agreed it is an incredible amp, my budget just cannot support keeping them both - wish I could! I will keep it a bit...
  5. C

    When to sell MV

    Hey guys. Looking for some advice here from the guys who have access to the V10 Beta. As each Firmware has dropped, I find myself getting closer and closer to selling my Mesa Mark V and just going solely with the II. Once 9.0 hit, I made the decision to sell the thing. In prep, I tone...
  6. C

    Thinking of buying an Axe-FX II and have some questions

    4CM for sure if you want to have access to the Rivera along with the Axe's other amp models. Just make sure you don't have an Amp model & the loop engaged in series in the same patch - unless that's your thing :). I previously had this setup with another modeller and my Mark V, but now have...
  7. C

    Axe FX II and PT 9...

    Yep. PT9 works fine with the MBP Built in Audio. I use it a lot with just the iLok plugged in.
  8. C

    Mesa Mark V Model/Preset

    Hey guys. Sorry about the delay, just saw the requests here for patches. Here is the one I have been working on, basically a tweaked version of Preset 13 "USA Lead". I adjusted Amp block basic and EQ pages to try and mimic the sound I am getting out of my Mark V Channel 3 Mark IV mode. Also...
  9. C

    Mesa Mark V Model/Preset

    Thanks much Cliff for the quick reply and the great advice. I basically have it dialed now and it sounds spot on, but the sliders on my amp block are in very different positions than on my MV. I guess I need to stop trying to emulate that 5 band EQ and just trust my ears. To NY Guitarist -...
  10. C

    Mesa Mark V Model/Preset

    Hey guys. I don't post a lot, usually getting what I need from reading so thanks for the great community and content. Also, Cliff want to say thanks for such a great product and updates - 3.0 is amazing!! When I purchased my II, it was more to compare to my Mark V as I had heard so many...
  11. C

    Pro Tools Reamp Help

    Hey Webb. I am doing reamping in PT. To start, for reamping you only need two tracks - one for the dry signal and one for the wet which will capture the output of the AF2 signal chain. For me, the wet corresponds to inputs 0&1 and the dry to inputs 2&3 in Pro Tools. Next make sure your dry...
  12. C

    PT 9 / Axe Fx 2 connecting

    You might want to try unplugging your 002, reboot PT9 and see if the II shows up. I have had a similar problem with PT9 where certain devices will only show up when they are the only unit connected. Good luck!
Back
Top Bottom