bulgmaf
Inspired
I want to rebuild some of my favorite AxeFx II presets in the Axe III from scratch (not sure I trust FracTool to get this right, given the constant FW updates). I was planning on picking up an ABY box so I could toggle between the two units, signal chain as follows: Guitar > ABY input > ABY output A into Axe II and ABY output B into the AxeFx III. Then each unit would input into my FRFR separately using input 1 and input 2 on my Atomic NEO CLR wedge.
It then occurred to me that maybe I could output my AxeFx II into the AxeFx III, then set up a footswitch on the FC-12 to toggle between the 2 units. I would then send only 1 output to the FRFR. Is this even a possibility? If it’s possible, how complicated?
It then occurred to me that maybe I could output my AxeFx II into the AxeFx III, then set up a footswitch on the FC-12 to toggle between the 2 units. I would then send only 1 output to the FRFR. Is this even a possibility? If it’s possible, how complicated?