Yes I did. But I have not seen the setting selection on Edit. Can you please let me know where it is? I’m away from the computer now but I’ll check later. ThanksDid you download the new edit? You’ll see it
This is how FM3 Edit 1.03.03 shows now the cab block. Clicking the IR length you select Standard or Ultra.Bug? In my FM3 Edit -- I have no setting in the Cab Block with which to select ultra res or standard -- please see attached snapshot. This is the case with my existing presets, as well as with any Cab I load (as shown in the snapshot) after having downloaded 3.03.
you are in mac or windows?Yes. But for some reason it doesn’t exist in mine
Bug? In my FM3 Edit -- I have no setting in the Cab Block with which to select ultra res or standard -- please see attached snapshot. This is the case with my existing presets, as well as with any Cab I load (as shown in the snapshot) after having downloaded 3.03.
Confirmed this (using Copy OUT 1 )....and care should definitely be taken as I/O configs can be dangerously borked with no knob control over OUT 2 at higher levels ..as I found out the hard way. rolled back to 3.02 as well.Well I just loaded it up and the Out 2 knob is unresponsive. There’s sound but when I raise or lower the knob nothing happens. I rolled back to 3.02 and it’s back to normal.
Alright, well in short: the Cab block "Cab" page in FM3 Edit is the same as it was in 3.02.You attached a preset (or cab IR), not a picture.
New drives are sounding GLORIOUS
Alright, well in short: the Cab block "Cab" page in FM3 Edit is the same as it was in 3.02.