FX8 - Is it able to switch between two amps?

4406cuda

Inspired
Can I use the FX8 to switch (A-B) between a dedicated clean combo clean amp and another amp I use for crunch and higher gain sounds?
 
Go to your fx8 edit click on config tab then relay1 or 2. You can assign which amp by scenes. Scene 1 can be clean, Scene 2 can be crunch, etc.
Go to foot switch tab and assign to any switch on the unit. assign a relay on one of the switchs on the unit like you would for any effect. Just use the relay1 or relay 2.
 
I haven’t tried it but I’d guess that if you’re not running stereo, you might be able to use the panner either with x/y or a cc pedal. Be sure to check your I/O settings. Of course this would only switch inputs, so each amp would still require a dedicated speaker.

You could also use relays if you have a separate switcher.
 
It can, but you're going to have to really fine tune.

Drop the $60 and get the radial bigshot ABY with grounding, iso and phase switches and be set.

That's what I did and no more hum, no more fuss.
 
Back
Top Bottom