Effect Status on Scene change

[teddis]

Hi,
Can't figure this out, if I could get some help please.

Setup
Switches 1-4 , Scene 1-4
Switches 5-8 , Drive,chorus,delay.reverb.

So I will be in scene 1, in default state, I will then engage some chorus, then I switch to scene 3, do my thing , then switch back to Scene 1........chorus is still on, meaning the preset is not in its default state, but last used...

Ho do I make it so each scene change reverts to the default state ?
thanks

 

[Admin M@]

Scene changes you make from the Axe-Fx III front panel (or Axe-Edit III) remain in effect until you save them or discard them by loading a different preset without saving. Changes made via footswitches or MIDI, however, may work differently, depending on a Global setting called Scene Revert. With Scene Revert turned on, Scene changes are discarded as soon as you load a new Scene. Here are two examples so you can compare how Scene changes work in both modes:

Ex 1: SCENE REVERT OFF (default)

1. You load SCENE 1. DRIVE 1 is OFF.
2. You turn DRIVE 1 ON with a Footswitch.
3. You change to SCENE 2.
4. You change BACK to SCENE 1.
5. Drive will be ON as you last left it.

Ex 2: SCENE REVERT ON

1. You load SCENE 1. DRIVE 1 is OFF.
2. You turn DRIVE 1 ON with a Footswitch.
3. You change to SCENE 2.
4. You change BACK to SCENE 1.
5. Drive will be OFF as you last saved it.

TO ENABLE/DISABLE SCENE REVERT…

1. Page to the General page of the MIDI/Remote menu under SETUP.
2. NAV to SCENE REVERT and set it “ON” or “OFF” as desired.
3. EXIT to finish. (You do not need to STORE changes in SETUP.)

 

[teddis]

Thank you Admin M !!