Using looper without it cutting out

[Terref69]

Does anyone know how to use or where to put the looper in line with out it cutting out when you play on top of it. i've messed with balance and other setting but when i play it cuts out. i will check the forum for more advice as well. thanks. ( yes I am new at this)

 

[flying_walrus]

Hi terref. Can you post a recording of it “cutting out” so we can hear what you’re hearing?

 

[Ugly Bunny]

Be sure "sync" is turned off. I had a whole thread about this - how it didn't seem to start back right away without a noticeable gap. As soon as I turned sync off, it was good.

 

[Admin M@]

Do install the latest firmware, version 2.0

 

[chris]

Does anyone know how to use or where to put the looper in line with out it cutting out when you play on top of it. i've messed with balance and other setting but when i play it cuts out. i will check the forum for more advice as well. thanks. ( yes I am new at this)

My looper doesn’t “cut out” so I don’t know what you mean.

 

[Moke]

Are you placing it in front of your distortion (Drive/Amp)???

 

[Terref69]

Be sure "sync" is turned off. I had a whole thread about this - how it didn't seem to start back right away without a noticeable gap. As soon as I turned sync off, it was good.

thanks for your reply

 

[Terref69]

Are you placing it in front of your distortion (Drive/Amp)???

yes right after input

 

[chris]

yes right after input

if you do that, then when you change sounds, the sound will change since the loop is before everything.

if you want to keep the same loop sound, then change your guitar sound without affecting the loop, the loop has to be AFTER everything. think about the signal path.