lqdsnddist
Axe-Master
Having had an issue with a noisy fan resulting from where the rubber isolation grommets were way over-tightened I had the top lid off my III. Easy enough issue to resolve myself (or FAS stated you can get an RMA if your one of the few individuals who may have this issue, I certainly don't think its very wide spread) and now my fan is nice and quiet.
I did notice that when the unit is powered up that there are a few active status LED's on the circuit board.
In the upper left hand corner there are three red LED's, and then on the riser board with the DSP there is a row of three red LED's which flash in sequence left to right.
Just wondering if they are all supposed to be active, or if they indicate any sort of fault. I'm guessing the upper left hand corner ones indicate the board is getting power.
Just curious
I did notice that when the unit is powered up that there are a few active status LED's on the circuit board.
In the upper left hand corner there are three red LED's, and then on the riser board with the DSP there is a row of three red LED's which flash in sequence left to right.
Just wondering if they are all supposed to be active, or if they indicate any sort of fault. I'm guessing the upper left hand corner ones indicate the board is getting power.
Just curious