Recent content by rkaczano

  1. R

    FCB1010 Pedal Calibration?

    The firmware for the G Force I am using is 2.04. I think this was the last version as per this G Force link: G-Force software versions When I link my expression pedals to a pitch shifter I notice that the pedal does seem to work at all levels 0% to 100%. This is a good sign. However when I...
  2. R

    FCB1010 Pedal Calibration?

    I will do that but I wanted to clarify a comment I made. When I said: "Yes I can confirm that the value knobs on the TC G Force yield the same results as the two Expression pedals." I was NOT using the INPUT/OUTPUT Dials on the left side of the G Force. I WAS using the Parameter and Value...
  3. R

    FCB1010 Pedal Calibration?

    I can confirm that the curve is in fact a stratight going from 0% to 100%. I went into MOD, clicked on the relevant mark for Ext1 and INPUT and hit ENTER to call up the curve. I then played with the values in the Low/Mid/High. What I noticed that usign the normal straight line I could not hear...
  4. R

    FCB1010 Pedal Calibration?

    Yes I can confirm that the value knobs on the TC G Force yield the same results as the two Expression pedals. I can also confirm that the pedal does actually work between 57%-100%. You can hear the value changes. So it clearly cannot be set-up as an On/Off. I think what I am hearing you...
  5. R

    FCB1010 Pedal Calibration?

    I looked into the CURVE of my effect in the G Force. It definately is set to 0/50/100. I set it to the INPUT parameter so that I could adjust the Input of the G Force. I then set it to 0/0/100 AND I set the pedal to the midway point (on the second 0). I then strummed the guitar and manually...
  6. R

    FCB1010 Pedal Calibration?

    I am having exactly the same problem. Dead zone from 50% and below on a brand new FCB1010. I have tried recalibrating over and over again to no avail. Note I am not using a Fractal. I am using a TC Electronics G Force. What is really odd is that when I go into my G Force, I can test the...
See more
Back
Top Bottom