Recent content by hanksta13

  1. H

    Smashing Pumkins, "Siamese Dream"?

    I always got spot on SD tones using the low input of my 2204 and a Big Muff or Red Llama pedal. I've never tried with my AXE3 though I'm sure it's achievable. I'm not sure if the low input of a JCM 800 is modeled in the Axe but that's the best pedal platform I've used with a real amp.
  2. H

    Axe-Fx III Firmware Release Version 14.00

    Really enjoying the HP Compulsion Distortion pedal into just about any amp.
  3. H

    RIP Neil Peart

    This one hurts bad. RIP
  4. H

    Presets MASTER THREAD - AustinBuddy's 1400+ NAKED AMPS TonePack for firmware Cygnus X2

    The “Great Koch-ry” preset is one of my favorites and it hasn’t even been updated yet. Such an awesome preset! Try it out!
  5. H

    Presets MASTER THREAD - AustinBuddy's 1400+ NAKED AMPS TonePack for firmware Cygnus X2

    Either way works, you could always just swap the outputs in the grid. I wish I could figure out a way to change the FRFR/ SS amp/cab settings independently for each output instead of in amp block. The updated presets sound AMAZING by the way! Axe3 is an amazing piece of gear and sounding...
  6. H

    Axe-Fx III Firmware Version 5.02

    Yes!! Thank you.
  7. H

    Axe-Fx III Firmware Version 3.02

    Seems to load quicker at power up too!
  8. H

    Axe-Fx III Firmware Version 3.02

    Thanks again!
  9. H

    Is CLR my best option

    I use a QSC K10.2 and a Yamaha DXR 10. The QSC is flatter and sounds better at lower volumes than the DXR IMHO. The QSC is a lot more flexible with its presets and EQ also. Both sound great at stage volume. Can’t comment on the CLR, never heard one in person. Tried the 10”&12” Friedmans and...
  10. H

    Presets MASTER THREAD - AustinBuddy's 1400+ NAKED AMPS TonePack for firmware Cygnus X2

    I know it’s a major firmware update so some probably need to be tweaked, but you asked so maybe you’re hearing the same on those.
  11. H

    Presets MASTER THREAD - AustinBuddy's 1400+ NAKED AMPS TonePack for firmware Cygnus X2

    Thanks for the filter slope tip, I’ll give it a try. Off the top of my head the Ruby Rocket, Blankenship, Bogner ecstasy gig rig blue modern 6l6 and a couple others scenes on ecstasy’s. A lot of the presets still sound great, I just noticed some sound flubby to me after 3.01.
  12. H

    Presets MASTER THREAD - AustinBuddy's 1400+ NAKED AMPS TonePack for firmware Cygnus X2

    I’m finding the opposite of what you’re hearing. I feel a lot of the naked amps presets sound muddy with a loose low end on 3.01. A few of the presets sound good but I’m awaiting your update for 3.01. I liked 2.0 and before best as far as I can remember lol for amp simulation. I don’t have the...
  13. H

    Anybody here tried the new Friedman ASC-10?

    I had both ASM12 and the ASC 10. The 10 was slightly better than the 12 I thought, but still colored the sound to much for my tastes. I was hoping it would have been a lot better sounding then the 12.
  14. H

    Anybody here tried the new Friedman ASC-10?

    Yes, didn't like it and sent it back. I'm using a QSC K10.2 and much happier with my sound. I thought the Friedman colored the sound to much. It kinda made all my Marshall presets sound the same. Just my opinion YMMV. Seems a lot of people like them and a lot don't.
Back
Top Bottom