Recent content by Baracus

  1. B

    FM3 Firmware Version 4.00

    Thank you. Sounding amazing and working great.
  2. B

    FM3 Firmware Version 4.00 beta 5

    Fan noise fixed. Thank you.
  3. B

    FM3 Firmware Version 4.00 beta 4

    Same issue here unfortunately. Beta2 does not have this issue for me.
  4. B

    FM3 Firmware Version 4.00 beta 3

    I am getting this as well. Same type of noise you describe. And yes, overall it sounds fantastic!
  5. B

    FM3 Firmware Version 4.00 beta 3

    I didn't realize that. Thank you.
  6. B

    FM3 Firmware Version 4.00 beta 3

    Unfortunately I still have out 2 issues when copying out 1. When copy out 1 is selected the out 2 output level changes to a choice between +4/-10. Shouldn't this still be a boost/pad selection on out 2 (which is present when out 1 copy is not selected)? The result is lower output for out 2 as...
  7. B

    FM3 Firmware Version 4.00 beta 2

    Yes, I'm noticing this as well now. Initially I had the proper volume for Out2 after upgrading however when I cycled the Output 2 Copy to None to test the output blocks I then started to notice the behavior you describe.
  8. B

    FM3 Firmware Version 4.00 beta 2

    Thank you. Out2 working fine now.
  9. B

    FM3 Firmware Version 4.00 beta 1

    Check the tone control display global setting. https://wiki.fractalaudio.com/wiki/index.php?title=Amp_block#Soft_reset_.28re-select.29
  10. B

    FM3 Firmware Version 4.00 beta 1

    Following up... I did another flash and no change. Eventually tried a third and disconnected out 2 during the process. This makes no sense to me for either action and is probably entirely coincidental but the problem is gone. Levels are as expected now. Back to playing. Thanks for yet another...
  11. B

    FM3 Firmware Version 4.00 beta 1

    Ever since 3.02 I've had lower output volumes on OUT 2 than previous firmware. For example 3.01 with OUT2 at about 9oclock now requires 12oclock on OUT2 for similar volume. I've done resets, checked cables, reverted back to 3.01 to make sure I wasn't crazy... But I still notice this with the 4.0...
  12. B

    FM3 Firmware Version 4.00 beta 1

    Thanks!
  13. B

    FM3 Firmware Version 3.03 beta 1

    I'm having the same issue. Volume knob on output 2 is unresponsive and sounds like it is at a very high level. I reset all parameters and no change. I'm using copy out1 to 2. Sounds great and no problems if using output 1 only.
  14. B

    FM3 Firmware Version 3.03 beta 1

    Thank you!
  15. B

    FM3 Firmware Version 3.02 Beta 1

    Yes, but this seems like a substantial difference between firmware? What was approximately the volume at 9 o'clock on the output 2 dial in 3.01 now requires 12 o'clock + for me. I reset and reverted back to 3.01 and volume was as expected. I then reinstalled the beta, reset, and have the same...
Back
Top Bottom