Recent content by 56panhead

  1. 56panhead

    If you're not sure...the FM9 is a beast!

    Hi. I had an FM3 and I found there was a noticeable delay when switching scenes. Do you notice a difference between FM3 and FM9? (for scene switching).
  2. 56panhead

    Deadpool’s FM9 Review

    Okay, Thank you!
  3. 56panhead

    Deadpool’s FM9 Review

    Do you notice a difference between FM3 and FM9? (for scene switching).
  4. 56panhead

    Deadpool’s FM9 Review

    Nope. Not connected to the editor.
  5. 56panhead

    Deadpool’s FM9 Review

    Hi. I have an Axe FX III + FC12. Love it. I got my hands on an FM3. I found the scene switch lag time was very annoying. What's the scene switch lag time like on the FM9?
  6. 56panhead

    Scene Switching Lag Time

    The FM3 had a noticeable increased lag time compared to the Axe FX III (with an FC12). Will the FM9 address this issue?
  7. 56panhead

    Audible Thump When Switching Presets

    @is9582: I was able to reduce the thump a bit by setting the Master Volume and Output Level to the same values. I used the Master Vol Trim to ensure that my levels (at the mixer) were the same for both presets. The thump is still there, and noticeable, but probably not serious enough to freak...
  8. 56panhead

    Audible Thump When Switching Presets

    @Fab8040: No delay in the block.
  9. 56panhead

    Audible Thump When Switching Presets

    Yup. My bad. Axe FX III.
  10. 56panhead

    Audible Thump When Switching Presets

    Here are two test presets. You'll notice the thump when going from Song A to Song B. It gets much more noticeable with a reverb block (which I always use...).
  11. 56panhead

    Audible Thump When Switching Presets

    I know this has been discussed before. With the Axe FX II, apparently it was fixed in a firmware update. But it's happening again with Axe II v16.05. It's especially noticeable if the two presets use different amps. The thump is serious enough to cause issues at performance levels. My output...
  12. 56panhead

    Graphic EQ Not Working

    Firmware 16.04
  13. 56panhead

    Graphic EQ Not Working

    Here's the preset.
  14. 56panhead

    Graphic EQ Not Working

    It's not in bypass. Like I said, the pan and level work, but not the sliders.
  15. 56panhead

    Graphic EQ Not Working

    I'm probably doing something stupid, but the GEQ block is not working. The balance and level controls work, but the sliders have no effect. What stupid thing am I doing or not doing?
See more
Back
Top Bottom