Hi Guys,
I'll try my best not to sound too much of a noob (but I am)
I just bought the EV-2. should i connect it to expression port 1 or two ?
can you please look to see if the cables I'm using are OK (attached picture)
Also - from the manual I did not quite understand this :
EV-1 AS AN ANALOG VOLUME PEDAL The EV-1 doubles as a high impedance ANALOG VOLUME PEDAL with a 500K audio-taper pot. When using the EV-1 as VOLUME PEDAL, connect between two instrument or line-level devices using the IN and OUT jacks of the EV-1 with standard unbalanced (mono) tip-sleeve (”TS”) instrument cables. Do NOT use Expression and Volume functions at the same time or ground loops can occur.
What does it mean to use them together ?
Thank you so much for your help.
I'll try my best not to sound too much of a noob (but I am)
I just bought the EV-2. should i connect it to expression port 1 or two ?
can you please look to see if the cables I'm using are OK (attached picture)
Also - from the manual I did not quite understand this :
EV-1 AS AN ANALOG VOLUME PEDAL The EV-1 doubles as a high impedance ANALOG VOLUME PEDAL with a 500K audio-taper pot. When using the EV-1 as VOLUME PEDAL, connect between two instrument or line-level devices using the IN and OUT jacks of the EV-1 with standard unbalanced (mono) tip-sleeve (”TS”) instrument cables. Do NOT use Expression and Volume functions at the same time or ground loops can occur.
What does it mean to use them together ?
Thank you so much for your help.