Messed up my MFC-101

stegre1

New Member
I started the week trying to update the scenes in a patch I created and it worked fine until I tried to add an additional reverb block into the patch and set up a footswitch to control it.

Through trying to do that, I lost the ability to move from scene to scene with the MFC101. Only "Scene 1" lights and the others say the are switching to "Scene 2" "Scene 3" and "Scene 4" but the the Axe-FX doesn't change.

Upsetting because I know it is something I did, but I cannot figure it out.

Now I am also getting a "AXE-FX NAME TIMEOUT!" screen.

I am using AXE edit and have a Axe-FX II XL and MFC101 Mark III.
 
Two things that I know of that will cause things to get funky like that; high CPU and/or a bad cable going to the MFC101. You did say you added another reverb block-check CPU and try a different MFC cable
 
Had this issue at the weekend when setting up my MFC.

Ended up changing the Ethernet cable and reseting the MFC and starting again - did the trick
 
Had this issue at the weekend when setting up my MFC.

Ended up changing the Ethernet cable and reseting the MFC and starting again - did the trick
How do you reset the MFC? I checked the manual and it only describes a factory settings reset. Is that the same thing?
 
Back
Top Bottom