if the guitar don't really do anything down there, I guess you could say then that I'm effectively dialling it out of the way
so maybe that'll have a similar effect as dialling the spike out with the low res's level control
Exactly.
if the guitar don't really do anything down there, I guess you could say then that I'm effectively dialling it out of the way
so maybe that'll have a similar effect as dialling the spike out with the low res's level control
I don't think I ever stated 95hz as the frequency. I can check them asap.
I think it was 117hz according to my measurements for Cab Pack 8.
I might actually create a thread where I can share the impedances as IRs for all the Cab Packs. Is there something wrong with using an impedance IR and setting speaker resonances to 0?
I think it was 117hz according to my measurements for Cab Pack 8.
I might actually create a thread where I can share the impedances as IRs for all the Cab Packs. Is there something wrong with using an impedance IR and setting speaker resonances to 0?
I haven't tried that low but being an audio engineer I can safely state that there's no place for guitar at 40hz. Actually I doubt many sound systems can even play those frequencies properly. F.ex. most kick drums have their low end around 60-80hz. Guitars are usually around 125hz. However like you said it might sound cool and breaking the rules is okay.
Well it's not like you make great sounding patches or anything.....oh yeah, never mind.E series JBL speakers have a low Freq Res at around 50-60hz... I've been setting my Low Res to 52hz on all my SRV patches.
They're custom mixes I did from Cab Pack 8. These are my go-to IRs atm.
Speaking of Low Res frequencies , If the low res setting on the amp page is the correct one for the model ,and that's based on the typical cab used with that amp . Why is the plexi 100 set at 114hz 2.000 Q , and the SLP 100 set at 72hz , 1.800 Q by default ? One would basicly use the same cab with either .
Yes.
No.
If you have a second unit you can shoot an IR of it before you update using the second unit.
I based the SLP on using it with G12H(55) speakers which have a resonance of 55 Hz. When mounted in a typical cab the resonance will be in the low 70s. There is no right or wrong. Whatever sounds best.
Try the FAS Lead 1.Which amps to use with these factory cabs(58 and 59)?