Wiring a cable from axe to monitor, Jack-XLR

pauliusmm

Fractal Fanatic
I would like to have a right angle jack going from axe to xlr male going to my Fbt monitor.
I've only wired jack-jack cables before, so maybe you can point me to some schematics.
Does it have to be a TS or TRS jack if it goes to output 2 on the axe?
 
Normally you would use a "balanced" cable and TS to XLR. Connect pin 2 to tip, pin 3 to sleeve and leave pin 1 (shield) floating on the unbalanced end (AxeFx).

I'm not sure if the humbuster thingy in the Axe outputs desires a different approach though...

Connection No 13:

n110fig4b.gif
 
Back
Top Bottom