Changing Presets with FCB1010 problems

[ghosttrooper]

Hi,

i have a question regarding the FCB1010 and the AXEFX (my Equipment : FCB1010, AxeFX, Midisport 2x2, Midi Merge)

At the time I can only switch presets with the up&down and 1-5 buttons of the FCB and only to preset 128 or so. When I now change the preset on the AXE unit itself to 130, I can switch to 258 (+12 with the FCB

1. how is it possible to access all presets on the AXE (not only 128 of it) – I know I have to edit the file in ripwerx, but don’t know how
2. how is it possible to change a preset of the AXE with the FCB by selecting its number --- example: to switch from preset 38 to 118
3. when switching a preset with the FCB or AXE unit, the preset does not change in the AXE EDIT software, it always stays the same till I change it manually in AXE Edit … can this be changed so that – no matter where to change the preset – all other units switch to the same preset#

thanks

in advance

[LAYGO]

Send a CC#0 with a value of 0-2 first:
0 = 0-127
1 = 128-255
2 = 255-384

The rest is RTFM.

[ghosttrooper]

Send a CC#0 with a value of 0-2 first:
0 = 0-127
1 = 128-255
2 = 255-384

The rest is RTFM.

OK thanks

what about 3. to change it all simultaneous?

[LAYGO]

what about 3. to change it all simultaneous?

Don't think #3 is possible (yet?). I typically change Axe-Edit, it'll change AFX, but then pedal is out of sync. Either use pedal or Axe-Edit, but there really isn't a scenario of needing both.

[shasha]

I can't remember if you can do this with the stock chip, but I know for a fact the Uno chip allows you to send the CC on a switch before the program change, but you have to use PGM5. So if you are setting it up so that you can select a preset of say 129, it would be CC# 00 01 PGM5 001 (or 002 if you don't use an offset). Basically it would be bank 2 preset 1. One button, one press of the switch.

But you have to use the course bank select (which is what we are talking about here) for every patch now or it will remain the last bank selected.

Oh yeah, you won't see PGM5 by default if you are using Ripwerx, you have to go into the view options and select it. The reason it works is because PGM5 is sent AFTER the CC.