Activity Stream

I disagree. And neither yours nor his belong in this thread. This is a useful thread, please stop trolling.

Linear 10k ohm IIRC

Thanks so much! I figured if nothing else I could run the midi out on the MFC101 to the midi thru on the X-15 and go that route, but this will be...

Like I said, I wouldn't worry about the xmax so much as you are only going to play guitar through them right? My Scorps are .25 mm, that's relatively...

Any ideas on a launch date for the next version of Fractal Bot?

Sorry to revisit an old thread, but am just learning my Axe-2 as far as building my presets goes. I would also like at least one more drive block....

Bump.

Cool, thanks. One more question. Does anyone know what type of potentiometer is used for an expression pedal compatible with the MFC? I would like...

This was strong and beautiful!

From my engineer at Blue Arran: "the EVM 12L does have quite a pronounced spike in its response range, which actually centres on the 3.5kHz figure...

Yes. I tried the toe on/off thing using midi values, but I'm so used to a real wah, that I use the whole sweep and it's hard to avoid turning it...

The Wrecker model is virtually unchanged from V9. I think the only significant changes were the Triode Hardness and the Transformer Match. For the...

Have you tried auto-engage? Auto-engage a controller - Axe-Fx II Wiki

thanks guys! :)

On the list 2/10 and received my invite today!

What other speakers, if any, have you tried with your Axe-Fx?

I wouldn't panic and revert just yet. I was thinking Cliff was working on something for us pre-V10 lovers. Maybe we don't even need that? I did...

Don't let it bother you - I love delay too. It's not over-bearing IMO. I love this kinds of music and you're playing is great. The tone does make...

Commands received at either Axe-FX port will be processed. BTW, the MFC doesn't have MIDI thru, only the ability to change presets when a PC is...

I love animals too! They are very tasty! I'm not offended by your lifestyle, and that picture was a joke - please try and take it in that...

No there is no way to "reset" scenes

Without resetting the amp type back and forth I've found the following to be useful in getting 9.02 tones in 10.05: Lower the graphic EQ on the...

actually his comment is spot on regarding most people's issues with V10.

It happens all the time. You use Axe Edit and work on some stuff and suddenly nothing happens and you see the message (IO NOT CONNECTED) and there is...

Please post a link to this thread in the BASS and OTHER INSTRUMENTS section of the forum if you can. Sounds great!

Did you leave a cable connected to rear In 1 L when trying the front input? That would prevent the front input from working. The input select in...